Installation of Vertical Fiber Optic Connector Sockets

To connect a vertical fiber optic connector socket, carefully terminate the fiber into the socket adapter, secure the pigtail, attach the faceplate, and connect your ONT or device using a compatible patch cable.

Step-by-Step Guide

1. Safety and Preparation

• Wear safety glasses to protect your eyes from invisible laser light emitted by fiber cables.
• Ensure the ONT laser is disabled via your ISP portal if applicable.
• Gather tools: fiber strippers, cleaver, alcohol wipes, crimping pliers, and the appropriate connector (SC/APC, LC, etc.), . 2. Install the Back Box
• Cut a wall opening (typically 60mm x 40mm) at a dry, accessible location near power outlets.
• Secure the back box with screws, ensuring a minimum depth of 40mm to accommodate fiber slack . 3. Prepare the Fiber Cable
• Strip approximately 30cm of the incoming fiber cable carefully, avoiding bends or kinks.
• Clean the exposed fiber with anhydrous alcohol to remove dust and contaminants .
• Coil any excess fiber inside the back box, maintaining a minimum bend radius of 30mm to prevent signal loss . 4. Connect the Fiber to the Socket
• Snap the pre-terminated pigtail connector into the socket adapter. For SC connectors, use the push-pull latch mechanism; for LC connectors, use the latch mechanism; for FC connectors, use the threaded screw mechanism .
• Ensure the ferrule end is clean and properly aligned to minimize insertion loss.
• Place the dust cap on the connector until ready to connect to the ONT . 5. Attach the Faceplate
• Secure the faceplate over the back box to protect the fiber and provide a neat, flush finish on the wall . 6. Connect to Your Device
• Use a compatible fiber patch cable (e.g., SC/APC to SC/APC) to connect the wall socket to your ONT or router.
• Measure light levels if possible; for GPON networks, a good range is typically -8 dBm to -27 dBm . 7. Final Checks
• Verify that the connection is stable and free from bends or stress.
• Ensure the fiber path is neat and the socket is easily accessible for future maintenance . By following these steps, you ensure a low-loss, reliable connection that maximizes fiber optic performance and protects the delicate fiber ends from damage.